沙特恢復執行插頭標準SASO 2203: 2015
沙特標準局SASO于2016年6月21日開會(huì )決定原推遲和暫緩執行的沙特標準SASO 2203: 2015版（適用于家用或類似用途的250V/13A插頭、插座測試方法及安規要求）現恢復生效，立即執行。但SASO2203: 2015其中幾個條款1.0.1、4.3.10.4、5.5.1 & 5.5.2（如下表）可暫時按照舊版SASO2203: 2003的相應條款執行，直到另行通知。
|
SASO 2203: 2015版 |
SASO 2203: 2003版 |
| C.1.0.1 配線導體的截面積不小于1.5mm2 | 對配線導體的截面積沒有明確要求。 因此，可以參考整機標準進行配線。 |
|
Cl.4.3.10.4 保險絲應滿足SASO 1899標準 |
Cl.4.3.8 規定的保險絲。（BS 1362 保險絲是可以接受的。） |
| Cl.5.5.1 & Cl.5.5.2 規定的溫升測試 | Cl.5.5 規定的溫升測試 |
原文公告如下
SASO’s Board of Directors held a meeting (Meeting No. 156) on 16th of Ramadan 1437 AH corresponding to 21st June 2016 and adopted the following resolutions: The mandatory application of some clauses of Saudi Standard No. SASO 2203: 2015 version has been postponed until further notice. The corresponding clauses from the previous version of Saudi Standard No. 2203 (i.e. 2003 version) shall be applied until the Standard is revised. The affected clauses have been identified and presented in the below Table.
|
SASO 2203: 2015 Version |
SASO 2203: 2003 Version |
| C.1.0.1: Conductor Cross Sectional Area | Corresponding clause for Conductor Cross Sectional Area is absent. Therefore the appliance standard is applicable for this requirement. |
|
Cl.4.3.10.4: Fuses |
Cl.4.3.8 for Fuses shall apply. |
| Cl.5.5.1 & Cl.5.5.2 Temperature rise Test | Cl.5.5 for Temperature rise Test shall apply |
GCC認證、CE認證、FCC認證、IEC報告、RoHS認證、中國RoHS、REACH認證、電池類UL4200A認證、LFGB認證、ErP認證、加州CP65認證、EN71認證、FDA認證、ASTM F963認證、CPSIA認證等相關產品檢測認證，歡迎來電咨詢！
